Serinus Energy Inc.: Brunei: Lukut Updip-1 Well Flows Gas at Non-Commercial Rates

CALGARY, ALBERTA--(Marketwired - Oct 18, 2013) - Serinus Energy Inc. (SEN.TO) ("Serinus", "SEN" or the "Company"), an international upstream oil and gas exploration and production company, advises that the Lukut Updip-1 ("LKU-1") well in Brunei Block L flowed gas continuously from two separate intervals that have not previously been penetrated by any wells onshore Brunei. While the rates were estimated at less than 50 thousand cubic feet per day ("Mcf/d"), the discovery of hydrocarbons within these zones indicates that further analysis and appraisal will be required to evaluate the resource potential of this play.

Test 1 (2,131 - 2,137 metres)

The LKU-1 well encountered a drilling break and a significant influx of gas with a total gas reading of 47% whilst drilling 6" hole starting at a depth of approximately 2,131 metres measured depth ("MD") (1,773 metres true vertical depth subsea ("TVD")) and continuing to a depth of at 2,137 metres MD, the last 3 metres of which is interpreted to be clean sand. C1 gas readings peaked at 332,000 parts per million ("ppm") and C5 gas readings peaked at 628 ppm at TD. Pressures rose significantly and there was material gas influx with total gas readings increasing to 47% which resulted in gas being flared at surface for several hours. The mud weight was subsequently increased to 17.7 pounds per gallon ("ppg") to control the calculated formation pressure of 5,366 pounds per square inch ("psi"). Due to the significantly higher than expected formation pressures and equipment limitations, the Company determined that it could no longer safely continue to drill the LKU-1 well and, consequently, a cement plug was put in place from 2,120 to the total MD of 2,137 metres and 4.5" casing was set to a depth of 2,120 metres. The initial planned depth for the LKU-1 well was 2,959 metres MD and 2,410 metres TVD.

The first zone to be tested was the bottom 6 metres of the well from 2,131 to 2,137 metres MD over which the cement plug had been placed. Gas flowed continuously at a low rate during the test. The formation is believed to have been damaged by heavy drilling fluid, mud system additives and cement during the drilling process as the drilling team worked to control the high pressures encountered. Attempts to clean up the perforated interval by utilizing an acid treatment were not successful.

Test 2 (1,980 - 2,120 metres)

During the drilling operation a general trend of increasing silt and/or sand content was observed from a depth of approximately 1,890 metres and continuing to 2,137 metres (a total thickness of 247 metres). The sandy/silty shale encountered over this section appears to be hydrocarbon charged, with C1 to C5 total gas readings increasing from a 10 metre average of 0.49% at 1,700 metres MD to a 10 metre average of 8.1% at 2,110 metres MD. C1 gas readings steadily increased from a 10 metre average of 3,150 ppm at 1,700 metres MD to a 10 metre average of 58,000 ppm at 2,110 metres MD. Based upon the increased pressures and associated hydrocarbon shows, the thick silty shale zone was selected as the second zone to be tested.