Toronto, Ontario--(Newsfile Corp. - February 4, 2025) - Appia Rare Earths & Uranium Corp. (CSE: API) (OTCQB: APAAF) (FWB: A0I0) (MUN: A0I0) (BER: A0I0) (the "Company" or "Appia") announces updated results from the Ionic Adsorption Clay (IAC) rare earth elements (REE) targets Maia, Electra, Taygeta and Merope at the PCH project (Map 1). (See August 20th, 2024 Press Release - Click Here) A total of 1,173 samples from 163 Auger drillholes were tested and confirm the presence of extensive IAC style REE mineralization and results show excellent desorption/recovery of the critical Magnet Rare Earth Oxides (MREO).
Tom Drivas, CEO, stated, "These excellent desorption results further confirm the presence of extensive IAC REE mineralization. The potential from these new zones could significantly increase the known quantity and quality of IAC mineralization as the auger drilling has only tested the upper 5-8 metres of the system with most drill holes ending in mineralization. This is in addition to the recently reported high grade hardrock carbonatitic breccia REE mineralization in the SW Extension zone of Target IV which was announced last week (see Press Release - Click Here). We are planning to execute additional drilling to further define key target zones, and to update the current Mineral Resource Estimate (MRE) of the PCH project while preparing for the execution of a Preliminary Economic Assessment (PEA) report."
Highlights:
Taygeta and Merope targets presented high potential IAC REE results with NdPr average desorption ranging from 35.0% to 60.1% and DyTb desorption from 37.3% to 43.9% in average and are considered the best targets to develop substantial Magnet Rare Earth Oxides (MREO) resources.
Taygeta Target overall recoveries: 33.8% Total Rare Earth Oxides (TREO), 34.5% Heavy Rare Earth Oxides (HREO), 60.1% NdPr and 37.3% DyTb.
Overall desorption results from the entire drilled interval from 118 auger holes (Table 1 above) show a high desorption for targets Taygeta, Merope and Maia where the Heavy Rare Earth Oxides (HREO) recoveries are higher than the light rare earth oxides.
Desorbability tests were conducted by ALS using an Ammonium Sulfate solution at 0.5M, pH4, for 20 minutes at room temperature and part of the samples were conducted at 0.5M Ammonium Sulfate, pH2, for 20 minutes at room temperature. No significant difference was found on results obtained from selected samples assayed under pH2 and pH4 as presented in table through this LINK.
Individual element recoveries (Table 2) consistently indicate high average recovery for Magnet Rare Earth Oxides (MREO) consisting of Neodymium (Nd), Praseodymium (Pr), Dysprosium (Dy) and Terbium (Tb).
Table 2 - Overall target average desorption recoveries by rare earth element.
Several auger drillholes stopped at mineralization due to the water table indicating the potential to grow the mineralized zone at depth.
The detailed location of the zones tested on each target are presented on maps 2, 3, 4 and 5 below. The mineralization is also open to the south and to the west of Taygeta IAC target, Northeast of Merope IAC target and to the south of Electra IAC target.
The results are from auger holes in the entire target and all of them presented smaller zones with better grades and recoveries and will be subject to further delineation and expansion drilling.
Auger drillholes are vertical and reported intervals are true thickness. The material produced from auger holes are sampled at one metre intervals,resulting in average sample sizes of 5-10 kg, no crushing or screening was executed. Quartering of the material was performed at Appia's logging facility using a riffle splitter and continued splitting until a representative sample weighing approximately 500g each was obtained, bagged in a resistant plastic bag, labeled, photographed, and stored for shipment.
The bagged samples are sent to the ALS laboratory in Goiânia, Goias for initial preparation and sent to Lima Peru for final analysis. In addition to the internal QA/QC of the ALS Lab, Appia includes its own control samples in each batch of samples sent to the laboratory.
Quality control samples, such as blanks, duplicates, and standards (CRM) were inserted into each analytical run. For all analysis methods, the minimum number of QA/QC samples is two standard, one duplicate and one blank, introduced in each batch which comprises full-length hole(s). The rigorous procedures are implemented during the sample collection, preparation, and analytical stages to insure the robustness and reliability of the analytical results.
All analytical results reported herein have passed internal QA/QC review and compilation. All assay results of RC samples were provided by ALS, a Certified Laboratory, which performed their measure of the concentration of rare earth elements (REE) with the ME-MS81 analytical method that uses lithium borate fusion prior acid dissolution and Inductively Coupled Plasma Mass Spectrometry (ICP-MS). Major Element Oxides were done using ME_ICP06 analytical method using lithium borate fusion and inductively coupled plasma atomic emission spectroscopy (ICP-AES)
Desorption analysis was performed by ALS using ME-MS19a analytical method with samples being crushed until 90% of material is smaller than 2 millimeters, no screening, followed by leaching using a solution of Ammonium Sulphate at 0.5 molar, pH 4, room temperature for 20 minutes. Some samples used desorption analysis using ME-MS19 analytical method with samples being leached with a solution of Ammonium Sulphate at 0.5 molar, pH 2, room temperature for 20 minutes. The leached solution content was analysed using ICP-AES/ICP-MS. No significant difference was found on results obtained from selected samples assayed under pH2 and pH4.
The technical information in this news release, including the information related to geology, drilling, and mineralization, has been reviewed and approved by Andre L. L. Costa, Appia's VP Exploration for Brazil. Mr. Costa is a APEGS Professional Geoscientist (P.Geo.) and a Fellow of Australian Institute of Geoscientists (FAIG), a Qualified Person (QP) as defined by National Instrument 43-101 - Standards of Disclosure for Mineral Projects.
About Appia Rare Earths & Uranium Corp. (Appia)
Appia is a publicly traded Canadian company in the rare earth element and uranium sectors. The Company holds the right to acquire up to a 70% interest in the PCH Ionic Adsorption Clay Project (See June 9th, 2023 Press Release - Click HERE) which is 42,932.24 ha. in size and located within the Goiás State of Brazil. (See January 11th, 2024 Press Release - Click HERE) The Company is also focusing on delineating high-grade critical rare earth elements and gallium on the Alces Lake property, and exploring for high-grade uranium in the prolific Athabasca Basin on its Otherside, Loranger, North Wollaston, and Eastside properties. The Company holds the surface rights to exploration for 94,982.39 hectares (234,706.59 acres) in Saskatchewan. The Company also has a 100% interest in 13,008 hectares (32,143 acres), with rare earth elements and uranium deposits over five mineralized zones in the Elliot Lake Camp, Ontario.
Appia has 153 million common shares outstanding, 177 million shares fully diluted.
Cautionary note regarding forward-looking statements: This News Release contains forward-looking statements which are typically preceded by, followed by or including the words "believes", "expects", "anticipates", "estimates", "intends", "plans" or similar expressions. Forward-looking statements are not a guarantee of future performance as they involve risks, uncertainties and assumptions. We do not intend and do not assume any obligation to update these forward-looking statements and shareholders are cautioned not to put undue reliance on such statements.
Neither the Canadian Securities Exchange nor its Market Regulator (as that term is defined in the policies of the CSE) accepts responsibility for the adequacy or accuracy of this release.
As part of our ongoing effort to keep investors, interested parties and stakeholders updated, we have several communication portals. If you have any questions online (X, Facebook, LinkedIn) please feel free to send direct messages.
To book a one-on-one 30-minute Zoom video call, please click here.
